Notice when installing freestanding sink

Many people will be installed in the bathroom or balcony – a freestanding sink, convenient for daily washing, hand washing, etc., that freestanding sink installation to pay attention to what? People who have not installed a freestanding sink, do not know what they have to pay attention to when installing it, you can also pay attention to some specific installation techniques, this article introduces you to what the freestanding sink installation techniques.

A, Column basin installation to pay attention to what

1,Need to pay attention to is between the basin to leave enough distance,

otherwise it will also have an impact on the daily use.

2, Due to this type of washbasin under the bracket staggered, disassembly and installation is more complex.

Then if the countertop length is small, it is also difficult to ensure quality when installing.

Wrap the raw material band around the sink, which can be slightly thicker.

So that it can strengthen the sealing of the pipe threads and prevent water leakage.

(Under the water device has two seals, the upper pool – one, the lower pool a, raw material single wrapped in between the two seals).

freestanding sink

3, We usually stand column type washbasin after installation,

the overall appearance is relatively neat and easy to take care of,

pay attention to the junction of the basin and the countertop is relatively easy to hide dirt and grime place,

we need to be regularly cleaned, to avoid it will occur mold.

Under the seal ring coated with glass glue

(under the seal ring and ceramic sealing is not very good,

the need for glass glue to strengthen the function of water seepage prevention).

4, Column basin for the installation of the requirements are still relatively high,

to first measure the size of the installation,

and then in accordance with the measured size of the custom installation bracket,

and then finally the basin installed to the intended location.

freestanding sink

Second, the column basin installation skills have what

1, Use the impact drill to punch a hole at the mark, install a good expansion tube.

2、Install the hooks, column fixings.

To pay attention to the installation of hooks can not be fixed screws screwed too tight, you can gently try to hang,

and then according to the vertical position of the column basin and the wall insert the metal piece for debugging,

if you need to tilt upward to insert the metal piece in the upper position,

if you need to tilt downward to insert the metal piece in the downward position. Next, then install the hook firmly.

3、Follow the requirements and steps on the instructions of the pillar basin,

first install the pillar basin on the hook.

Then install the washbasin fixed pieces, if the choice of metal parts fixed installation of friends,

you can set on the fixed pieces of metal parts,

followed by its screw installation hole into the fixed bolt

freestanding sink

(Note: please fix the metal parts fastened to the lower surface of the fixed hole);

if the ceramic hole directly in the fixed installation of friends,

after the gasket set, and then from the ceramic hole to install on the fixed bolt.

4、Begin to connect the inlet pipe parts and drainage pipe parts, warm tips:

according to the different drainage pipeline, the best choice of drainage pipe.

Then connect the column with the fixed parts.

5, Anti-mould work is very important, otherwise with a long time is likely to appear mould, affecting the beauty and health.

It can be sealed with anti-mould silicone between the foot of the column,

the top of the column basin and the contact surface of the wall and the ground.

See more freestanding sink, please follow us!